Get an instant estimate of the cost for your new worktop in seconds using this Calculator. Enter your dimensions, choose your edge type, and add any extras. Our Kitchen Worktops Price Calculator gives you a quick material cost so you can plan your budget before speaking to our team. There are many factors affecting the actual price of a worktop, such as stone type, project complexity, and stone fabricator, so the calculator’s output can only be considered an approximate budgeting tool.
Total Area: 0 m²
Single Arris
Double Arris
Single Radius
Double Radius
Mitred Arris
Mitred Radius
Rolled
Dupont
Demi Bullnose
Half Bullnose
Full Bullnose
Double Full Bullnose
Ogee
Ogee Bullnose
Sharknose Standard
Sharknose Square
Inverted Sharknose
Getting accurate measurements is the most important step before using this calculator. Here is what to keep in mind:
Measure in metres: If you have measured in millimetres or centimetres, convert before entering. For example, 2400mm = 2.4m and 600mm = 0.6m.
Measure the full depth of the worktop, not just the visible surface. Standard kitchen worktop depth is 600mm (0.6m), but always measure your worktop.
Include overhangs: If your worktop overhangs a breakfast bar or island, measure to the full outer edge, not the cabinet edge.
For L-shaped kitchens, do not try to enter it as one measurement. Use the “Add More” button to split it into two separate sections, one for each run.
For islands and peninsulas, add these as separate sections as well, since they are independent pieces of stone.
Always add 10–15% for waste. Stone cutting always produces offcuts. Adding a small buffer to your area ensures you are not underestimating.
It gives a solid material cost estimate based on the dimensions and options you enter. The actual price may vary slightly depending on your chosen stone, slab availability, and specific project requirements.
Please check with our team when you request a quote, as VAT applicability can depend on the nature of the supply.
Yes, use the same calculator. Simply enter the dimensions of your vanity top and choose the relevant edge type.
For non-rectangular shapes, enter the maximum length and maximum width as if it were a rectangle. This gives a close enough estimate, and our team will refine it during templating.
Use this calculator to get your material estimate, then click “Get a Quote”, and our team will come back with a full, accurate price, including templating and installation.
Simply contact our team by giving us a call at 0203 150 1198 or get a quote online.
